what did/are you ladies using to glue the invitation to the pocketfold? i have these zots.. which work very nicely.. however i was hoping to find an alternative that would move along a little faster.. i've been doing this for an hour this morning and i have about 15 invites glued.. any other suggestions?
sumbr08
Posted:
Member since
Re: assembling invitations...
How about using a xyron machine. You put the invitation through the machine and it comes out with the back as an adhesive. I think it would be much quicker. You can get one at ac moore and I think they have a 50% off coupon in their flyer. I bought one yesterday and it came to sixteen dollars with the coupon.
MikeandJess
Posted:
Member since
Re: assembling invitations...
Posted by sumbr08
How about using a xyron machine. You put the invitation through the machine and it comes out with the back as an adhesive. I think it would be much quicker. You can get one at ac moore and I think they have a 50% off coupon in their flyer. I bought one yesterday and it came to sixteen dollars with the coupon.
do you have a picture of the one you bought. I know there is a very expensive one and I dont' think that's the one you're talking about. I didn't know which one to purchase
sumbr08
Posted:
Member since
Re: assembling invitations...
It's called the xyron 500 5''by18''
Katie&Chris2006
Posted:
Member since
Re: assembling invitations...
i use Fabri-tac glue for all the invites I make. It's available at Michaels or AC moore.
iwannabmrsD
Posted:
Member since
Re: assembling invitations...
xyron is not a bad idea.. i have a xyron 900... that's actually a pretty good idea...
xBrunette
Posted:
Member since
Re: assembling invitations...
i have the xyron 900.. and i love it!! i started making my invitations.. and it works great... and i'm using it to make my STD too! they have a magnet cartridge...
BlueIGirl04
Posted:
Member since
Re: assembling invitations...
I used double sided permanent tape. You could also use the glue tape. Make sure it is permanent though. I just finished doing this last night.
Good luck!
iwannabmrsD
Posted:
Member since
Re: assembling invitations...
yes!! i used the xyron 900 for my std magnets.. that is a wonderful machine..
