I am trying to print table names in place them in a pretty frame. Only problem I'm having is that I cannot get the letters to print large enough. Any ideas. Thanks ladies
Jesaroo2
Posted:
Member since
Re: Can Anyone Help Me.
hm Im not to sure what you mean... Id love to help if you could try it explain it better?
Espo22
Posted:
Member since
Re: Can Anyone Help Me.
are you going to page set up and adjusting it to the size paper you have?
Espo22
Posted:
Member since
Re: Can Anyone Help Me.
Posted by Espo22
are you going to page set up and adjusting it to the size paper you have?
and if you did adjust it to the size paper you have, then make it larger than what your paper actually is...this happened to me once, when i put in the size paper it was, the letters came out too small...i adjusted the settings again in page set up and made the paper size just a little bit larger
missigreg
Posted:
Member since
Re: Can Anyone Help Me.
how big are you trying o get the typing to be?
NowAndForever2012
Posted:
Member since
Re: Can Anyone Help Me.
Thanks ladies for your help. I am going to try to adjust the paper size.....
