WOW!!! the candle is gorgeous! i love the ribbons! how did you do that? i want to make a memorial candle for FH's mom and put text on it, but not sure how to do it!!
ok..... For the large pillar: 1. I printed on vellum the same words as my DIY invitations. 2. Cut it to the desired height and diameter around the pillar (I left a little extra to overlap in the back like 1/4'. I attached it to the pillar using pins and double face tape. 3. I attached the ribbon again using pins (the simple sewing kind with a flat head) I used the pins at the seam and in the center of the ribbon around the diameter (the ivory ribbon covered the pins and kept the brown in place) 4. I left a little extra brown ribbon so that could fold it over it's self and make a little helm (with hot glue), so it does not fray and hid the pins too. 5. I attached the ivory/rose/pearl ribbon with a little hot glue.
Tapers used the same technique with the tapers for the brown and ivory ribbon (but I had to buy wire cutters to trim the pins, they would have gone right through the other side.
I hope this helps.....I just could not find any unity candles I loved. --the ivory/rose ribbon I've had for years --the brown ribbon (by the yard) only needed 1 yd at ACmoore --Vellum, Acmoore --Candles were from Michaels
Total Cost, about $12 (without looking for the receipts)