Table Help

---

Posted by BRIDE2K7

I am trying to print table names in place them in a pretty frame. Only problem I'm having is that I cannot get the letters to print large enough. Any ideas. Thanks ladies

---

Are you using a Word document ?? It says it only goes upto 72 nut you can just put any number in the area for font size like '100' & it'll do it. HTH's

---

Posted by imas98

---

Posted by BRIDE2K7

I am trying to print table names in place them in a pretty frame. Only problem I'm having is that I cannot get the letters to print large enough. Any ideas. Thanks ladies

---

Are you using a Word document ?? It says it only goes upto 72 nut you can just put any number in the area for font size like '100' & it'll do it. HTH's

---

Yes, but when I place a number to high for the font size it prints in two pages.

I'm not sure what your page settings are..but if you go to page setup and play with the margins tab that should help..also go to the layout tab within page setup and under the part that says 'page' vertical alignment select 'center'

HTH

if you're still having trouble..you can FM me one page of what you're trying to do and maybe i can help you...

i can't promise anything though!!

---

Posted by KickinDandelions

I'm not sure what your page settings are..but if you go to page setup and play with the margins tab that should help..also go to the layout tab within page setup and under the part that says 'page' vertical alignment select 'center'

HTH

if you're still having trouble..you can FM me one page of what you're trying to do and maybe i can help you...

i can't promise anything though!!

---

Thanks I will keep you in mind. I am at work so I am unable to check it at work. Thanks

sure! i'm at work too but no one cares

I didn't bring the paper with me;
-)