I got my program and menu paper from paper presentation and made them on my printer at home. It was relatively simple, just time consuming. Having made them my advice would be get a ribbon that fits into the holes easily. The holes on the paper I purchased were really small, so it gives a great finished product, but it is difficult to thread. I pre cut all of my ribbon by looping it around the outside of the part that would have the ribbon all the way around and then added a little bit more for good measure, this way I could thread them and then cut off the excess that got ruined. Another trick I learned when threading use a bobby pin to hold the ribbon it makes the ribbon go through the hole a lot easier. HTH. Lisa
