Re: What is everone doing (or have done) for placecards???
Olgaki - I can emial you the directions that I got from Marthastewart weddings - I think it wa the Fall 02 magazine.
I also posted the directions once.
shelzyp
Posted:
Member since
Re: What is everone doing (or have done) for placecards???
instructions for 'seating cards'
The seats are made with heavyweight paper - they used pale yellow for ladies and pale blue for men.
They can be calligraphied or run through the printer.
If calligraphing the names and numbers then do so after the cahirs are made.
THe name goes on the panel on the back, and the table number goes on the panel for the seat.
1. to form each paper chair, you will need one 11 x 2 1/4 stripof card stock, you can fit three on an 8 1/2 by 11 inch sheet. Use a bone folder to score each strip into four sections: a top that's 4 1/4 inches long, then three equal 2 1/8 inch sections.
2. Fold the strip at the top score line; the short section of the l will be the chair's back.
3. Bring the horizontal part of the strip down as shown, and fold at the next score line, forming the chair back and starting the seat.
4. Fold the strip down at the front of the seat to make the front legs. Use a glue stick or double sided tape to secure the two layers of the chair together. Set right-side up, and trim, if necessary
mishandgerard
Posted:
Member since
Re: What is everone doing (or have done) for placecards???
I used my favors, which were picture frames
endlessluv429
Posted:
Member since
Re: What is everone doing (or have done) for placecards???
what is the website for that wax inspirations? anyone?? i couldn't find it.
dawnie
Posted:
Member since
Re: What is everone doing (or have done) for placecards???